• <code id="0omuc"><blockquote id="0omuc"></blockquote></code>
  • <acronym id="0omuc"></acronym>
  • <bdo id="0omuc"><input id="0omuc"></input></bdo>
  • <tt id="0omuc"><object id="0omuc"></object></tt>
    <label id="0omuc"></label>
    <tt id="0omuc"><object id="0omuc"></object></tt>
  • Vacuum pouring equipment

    News

    Keywords

    Contact us

    Shenyang zhongzhen tuoda technology co. LTD

    Address: new civil law hanniu industrial park, shenyang city, liaoning province 221

    Telephone: 024-87704056

    Fax: 024-87705459

    Email address: sytdvac@126.com

    Phone: 13904029788

    Website: www.celloroller.com

    Maintenance of vacuum oil filling equipment

    Your current location: Home >> News >> Industry News

    Maintenance of vacuum oil filling equipment

    Published: 2018-06-14 Author: Clicks:

    Maintenance of vacuum oil filling equipment

    1. During the drying process, operators are required. Min check the drying condition and make relevant records.

    2, vacuum meters and thermometers should be checked regularly. Regular inspection of the rotation of the moving parts is flexible enough to find problems should be timely parking repair, not forced to use.

    3, cylindrical worm reducer (or CVT) should be maintained according to its instructions.

    5, the filter in the tank is dried once, that is, to remove the surrounding powder and make the filter unblocked.

    6, chain drive chain, at least once a month.

    7. Rotary bearing sealing ring (made of fluororubber) is used between vacuum tube and main engine. When air leakage is found, it should be replaced immediately.

    1. After receiving the drying notice, start the vacuum pump, open the vacuum pump valve of the dryer, close the vent valve to check whether the vacuum of the dryer meets the requirements.

    2. Start the power supply of the dryer and rotate the button of the speed regulator to make the drum of the dryer rotate slowly. Turn the feeding drum manhole of the dryer to the top of the drying table and stop turning.

    3. Feeding mode

    3.1 vacuum pumping

    The inlet of the dryer is connected with the feeding pipe, and the feeding pipe is vacuum pumped. After the wet material is pumped out, the feeding pipe is unloaded and the feeding valve is closed.

    3.2 directly from the dryer drum manhole cover feed.

    Close the vacuum valve of the dryer drum, open the empty valve, open the empty valve slowly, and put the pressure inside the drum at normal pressure, close the empty valve. Open Kong Gai, put the dry material into the drum. After entering the material, cover Kong Gai and tighten the screws.

    The content of the article comes from the Internet. If there are any questions, please contact us.

    Vacuum filling chamber

    Vacuum filling chamber

    This article URL: http://www.celloroller.com/en/news/398.html

    Keywords: Vacuumfillingchamber

    Recently Viewed:

  • Service
  • Telephone
    13904029788
  • Message
  • 在線咨詢
  • <code id="0omuc"><blockquote id="0omuc"></blockquote></code>
  • <acronym id="0omuc"></acronym>
  • <bdo id="0omuc"><input id="0omuc"></input></bdo>
  • <tt id="0omuc"><object id="0omuc"></object></tt>
    <label id="0omuc"></label>
    <tt id="0omuc"><object id="0omuc"></object></tt>
  • 性荡视频播放在线视频_亚洲午夜福利717_GOGO大胆全球裸XXXX_国内少妇毛片视频